Wednesday, September 7, 2011

 Comparison of Mobile Internet Access methodes



Common
Name
FamilyPrimary UseRadio TechDownstream
(Mbit/s)
Upstream
(Mbit/s)
Notes
HSPA+3GPPGeneral 4GCDMA/FDD
MIMO
21
84
672
5.8
22
168
HSPA+ is widely deployed. Revision 11 of the 3GPP states thatHSPA+ is expected to have a throughput capacity of 672 Mbps.
LTE3GPPGeneral 4GOFDMA/MIMO/SC-FDMA100 Cat3
150 Cat4
300 Cat5
(in 20MHz FDD) [31]
50 Cat3/4
75 Cat5
(in 20 MHz FDD)[31]
LTE-Advanced update expected to offer peak rates up to 1 Gbit/s fixed speeds and 100 Mb/s to mobile users.
WiMAX802.16Mobile InternetMIMO-SOFDMA128 (in 20MHz bandwidth FDD)56 (in 20MHz bandwidth FDD)WiMAX update IEEE 802.16m expected to offer peak rates of at least 1 Gbit/s fixed speeds and 100 Mbit/s to mobile users.
Flash-OFDMFlash-OFDMMobile Internet
mobility up to 200mph (350km/h)
Flash-OFDM5.3
10.6
15.9
1.8
3.6
5.4
Mobile range 30km (18 miles)
extended range 55 km (34 miles)
HIPERMANHIPERMANMobile InternetOFDM56.9
Wi-Fi802.11
(11n)
Mobile InternetOFDM/MIMO300 (using 4x4 configuration in 20MHz bandwidth) or 600 (using 4x4 configuration in 40MHz bandwidth)
Antenna, RF front end enhancements and minor protocol timer tweaks have helped deploy long range P2P networks compromising on radial coverage, throughput and/or spectra efficiency (310km& 382km)
iBurst802.20Mobile InternetHC-SDMA/TDD/MIMO9536Cell Radius: 3–12 km
Speed: 250km/h
Spectral Efficiency: 13 bits/s/Hz/cell
Spectrum Reuse Factor: "1"
EDGE EvolutionGSMMobile InternetTDMA/FDD1.60.53GPP Release 7
UMTS W-CDMA
HSDPA+HSUPA
UMTS/3GSMGeneral 3GCDMA/FDD


CDMA/FDD/MIMO
0.384
14.4
0.384
5.76
HSDPA is widely deployed. Typical downlink rates today 2 Mbit/s, ~200 kbit/s uplink; HSPA+ downlink up to 56 Mbit/s.
UMTS-TDDUMTS/3GSMMobile InternetCDMA/TDD16Reported speeds according to IPWireless using 16QAM modulation similar to HSDPA+HSUPA
EV-DO Rel. 0
EV-DO Rev.A
EV-DO Rev.B
CDMA2000Mobile InternetCDMA/FDD2.45
3.1
4.9xN
0.15
1.8
1.8xN
Rev B note: N is the number of 1.25 MHz chunks of spectrum used. EV-DO is not designed for voice, and requires a fallback to 1xRTT when a voice call is placed or received.